电工胶带UL认证，UL认证样品要求

使用微信扫描二维码分享朋友圈，成交更快更简单！

胶带UL认证UL510测试

连接端子UL认证 泉州工厂UL认证 PCB单面板UL认证 北京工厂UL认证 UL746DUL认证 CR塑胶料UL认证
胶带UL510认证
1 Scope

1.1 This Standard covers thermoplastic and rubber tapes for use as electrical insulation at not more than 600 V and at 80°C (176°F) and lower temperatures on joints and splices in wires and cables in accordance with the National Electrical Code, NFPA 70. It is intended that rubber tape on a joint or splice be mechanically protected by a covering such as friction tape. Thermoplastic tape is acceptable without the additional mechanical protection.

1.2 The characteristic constituent of the thermoplastic tape covered in this Standard is either PVC (polyvinyl chloride or a copolymer of vinyl chloride and vinyl acetate), or PE (thermoplastic polyethylene). For the characteristic constituent(s) of rubber tape, see 18.1.
Cover
Transmittal
Table of Contents
Body
INTRODUCTION
1 Scope
2 Components
3 Units of Measurement
4 Referenced Publications
ALL TAPES
5 General
6 Flame Test
7 Sunlight Resistance Test
THERMOPLASTIC TAPE
8 Thickness
9 Physical Properties Tests
10 Dielectric Breakdown Test
11 Test for Adhesion Strength
12 Moisture Absorption Test
13 Exposure to Heat Test
14 Exposure to Cold Test
15 Deformation Test
16 Storage Test
17 Test for Indirect Measurement of Conductor Corrosion
RUBBER TAPE
18 Compound
19 Thickness
20 Separator
20.1 Material, position, and coverage
20.2 Sticking and unraveling tendency
21 Physical Properties Tests
22 Storage Test
23 Dielectric Breakdown Test
MARKINGS
24 General
APPENDIX A
详询Sunny 陶静
连接端子UL认证,泉州工厂UL认证,PCB单面板UL认证,北京工厂UL认证,UL746DUL认证,CR塑胶料UL认证
连接端子UL认证,泉州工厂UL认证,PCB单面板UL认证,北京工厂UL认证,UL746DUL认证,CR塑胶料UL认证
连接端子UL认证,泉州工厂UL认证,PCB单面板UL认证,北京工厂UL认证,UL746DUL认证,CR塑胶料UL认证
连接端子UL认证,泉州工厂UL认证,PCB单面板UL认证,北京工厂UL认证,UL746DUL认证,CR塑胶料UL认证